AJ6-800-BAJ | ARTO Configuration

Please contact us immediately if a product link is no longer valid!

We recommend to install the copter AJ6-800 Basic Airjib (AJ6-800-BAJ) with the following components. This is merely a suggestion. At any time the components can be replaced by other parts of your choice.

Componenents for the copter

Motor | T-Motor MN3110 470KV

Required Quantity: 6 pieces

Propeller | T-Motor Carbon Fiber Prop

Required Quantity: 6 pieces

ESC | T-Motor AIR 40A

Required Quantity: 6 pieces

Flight Control System | DJI Naza V2

Required Quantity: 1 piece

Note: If you are using a redundant system (see the following component) two flight management systems will be needed.

Redundancy System

Required Quantity: 1 piece (optional)

Note: In many cases you will require a redundant system in order to get approved by the national aviation authorities. Additionally you will require a second flight management system. When a fault or failure occurs the redundant system will switch from the 'master' to the 'slave' setting. Please contact us directly, we are happy to advise you.

On Sceen Display | DJI iOSD mini

Required Quantity: 1 piece (optional)

Telemetry Sensor | UniSens-E

Required Quantity: 1 piece (optional)

Note: Telemetry sensor to control the battery voltage.

FPV Transmitter | 5.8GHz ImmersionRC 25mW A/V Transmitter

Required Quantity: 1 piece (optional)

FPV Camera | Fatshark 600TVL CMOS Camera

Required Quantity: 1 piece (optional)

FPV Monitor | Black Pearl 7" 5.8GHz Diversity Monitor

Required Quantity: 1 piece (optional)

Note: Monitor with integrated 5.8GHz diversity receiver.

Antennas | ImmersionRC SpiroNET Omni 5.8GHz CP Antenna

Required Quantity: 2 pieces (optional)

Note: One antenna each for transmitter and receiver.

Battery | Zippy Compact 25C Series 5800mAH 4S

Required Quantity: 4 pieces

Note: We recommend the use of at least four units. One flight requires 2 batteries.

Remote Control

Required Quantity: 1 piece (optional)

Note: We are happy to advise you in selecting the appropriate remote control. We recommend a 2.4GHz system with at least 8 channels.

Components for the gimbal

Controller | Basecam SimpleBGC 32-bit AlexMos Board (tiny version)

Required Quantity: 1 piece

Bluetooth Adapter | Bluetooth Module for AlexMos Brushless Gimbal Controller

Required Quantity: 1 piece (optional)

FPV Transmitter | 5.8GHz ImmersionRC 25mW A/V Transmitter

Required Quantity: 1 piece

HDMI 2 AV | FPV Mini HDMI Converter

Required Quantity: 1 piece

FPV Monitor | Black Pearl 7" 5.8GHz Diversity Monitor

Required Quantity: 1 piece

Note: Monitor with integrated 5.8GHz diversity receiver.

Antennas | ImmersionRC SpiroNET Omni 5.8GHz CP Antenna

Erforderliche Anzahl: 2 pieces

Note: One antenna each for transmitter and receiver.

Battery | Conrad Enery 15C 1600mAh 3S

Required Quantity: 1 piece

Remote Control

Required Quantity: 1 piece (optional)

Note: We are happy to advise you in selecting the appropriate remote control. We recommend a 2.4GHz system with at least 6 channels.